DMX ModeIn this mode, dimmer packs are addressable and may be DMX ModeDMX Modeused with any controller working on DMX protocol. In this mode, dimmer packs are addressable and may be used In this mode, dimmer packs are addressable and may be used with any controller working on DMX protocol. Up to 36 Up to 36 dimmer packs may be connected in series. with any controller working on DMX protocol. Up to 36 dimmer packs may be connected in series. For applications dimmer packs may be connected in series. For applications DMX or AnalogFor applications exceeding 36 dimmer packs, a splitter is Inexceeding 36 dimmer packs, a splitter is required. Consult exceeding 36 dimmer packs, a splitter is required. Consult required. Consult factory on details of DMX Splitters.factory on details of DMX Splitters.factory on details of DMX Splitters.Analog Mode 0-10/1-10VDCAnalog Mode 0/1-10 VDCAnalog Mode 0/1-10 VDCFor operation from devices using 0-10/1-10VDC protocol, For operation from devices using 0/1-10 VDC protocol, For operation from devices using 0/1-10 VDC protocol, up to 10 dimmer packs may be connected in series. For up to 10 dimmer packs may be connected in series. up to 10 dimmer packs may be connected in series. For applications exceeding 10 dimmer packs, an additional feed For applications exceeding 10 dimmer packs, an addi-applications exceeding 10 dimmer packs, an additional feed from the analog dimming device is required. tional feed from the analog dimming device is required.from the analog dimming device is required. Part #: LC-DMR LC-DMRJ/AThe remote wall dimmer has a rotary Part #: LC-DMR The remote wall dimmer has a rotarydial and on/off switch. Power to the wall dimmer is provided from the LED Driver dial and on/off switch. Power to the wallThe remote wall dimmer has a rotary powering the first dimmer pack. The unit dimmer is provided from the LED Driverdial and on/off switch. Power to the wall installs in a single-gang box.powering the first dimmer pack. The unitdimmer is provided from the LED Driver installs in a single-gang box.powering the first dimmer pack. The unit installs in a single-gang box.Part #: LC-1CH-DP LC-1CH-DPJEach dimmer pack receives a 24 VDC input Each dimmer pack receives a 8VDC inputfrom an LED Driver and sends a PWM output from an LED driver and sends a PWM outputPart #: LC-1CH-DP to the fixture. Logic input and output to the fixture. Logic input and output is Each dimmer pack receives a 24 VDC input is communicated through CAT5 cable. communicated through CAT5e cable.from an LED Driver and sends a PWM output Max. Load: 96 watts @ 24 VDCMax. Load : 40W @ 8VDCDimensions: 1-1/2" x 3-1/2" x 4-1/16"to the fixture. Logic input and output Dimensions : W89 x L103 x H36mmis communicated through CAT5 cable. Max. Load: 96 watts @ 24 VDCDimensions: 1-1/2" x 3-1/2" x 4-1/16"PRECAUTIONSPart #: LC-1CH-MULTILC-1CH-MULTIPart #: LC-1CH-MULTITechnical Specifications :Technical Specifications:Technical Specifications:Max. Load : 40W @ 8VDCMax. Load: 96 watts @ 24 VDCEnvironmental Rating : Dry Location/IP20Max. Load: 96 watts @ 24 VDCEnvironmental Rating: Dry Location/IP20Dimensions : W40 x L90 x H20mmEnvironmental Rating: Dry Location/IP20Dimensions: 3/4" x 1-3/4" x 3-1/2"Weight : 50gDimensions: 3/4" x 1-3/4" x 3-1/2"Weight: 50g / 0.11 lbsListing : ETL Listed/CE CertifiedWeight: 50g / 0.11 lbsOperating Temperature : 0~+50°CListing: ETL Listed/CE CertifiedListing: ETL Listed/CE CertifiedOperating Temperature: 0~+50ºCOperating Temperature: 0~+50ºC0/1-10 VDC In0/1-10 VDC In8VDCDMX InDMX InLC-DMRLC-DMR8VDCPWM SignalPWM Signal24 VDC24 VDC24 VDC24 VDCLED DriverLED Driver24 VDC0/1-10 VDC to next Dimmer Pack0/1-10 VDC to next Dimmer PackFixtureDimmer Dimmer PackPackLED DriverDMX to next Dimmer PackDMX to next Dimmer PackSignal to next Dimmer PackFixtureSignal to next Dimmer PackPWM SignalSignal out8VDCLED DriverLED DriverDimmer PackDimmer Dimmer PackPackLC-1CH-DPJDimmer PackDimmer Pack4228575Wall Dimmer4. Installation must comply with the National Electrical Code, or all applicable codes.5. Turn main supply to LED Driver on only after all connections have been made and tested. 6. Use only LED Drivers provided by Tokistar with the system.DimmerLED DriverDMX or Analog Out24VDC(+), Signal24VDC(-)PWM SignalDimmer PackLED DriverDMX or Analog OutSignal outFixtureFixtureFixtureFixture8VDCLED DriverFixtureFixtureFixtureLED DriverPRODUCT GUIDE(mm)LDR8-40Tokistar’s LDR8-40 is a 40 Watt LED driver used to convert an AC input into an 8VDC output. It may be operated from a wide range of input voltages.SpecificationsInput Range : 90-305VACFrequency Range : 47-63HzOuput : 8VDC (Adjustable +5% / -30%)Max. Output Current : 5.0AMax. Output Power : 40WProtection : Overload, Overcurrent, Short Circuit Operating Temperature : -30°C to + 60°C Mechanical SpecificationsDimensions : 75 x 285 x 42mmWeight : 0.97kgEnclosure Rating : Nema 3/IP65Mounting : Flange MountConnection : Knockouts for 1/2" ConduitLED Capacity0.10 Watt LEDs : 400 each0.20 Watt LEDs : 200 each0.40 Watt LEDs : 100 each1. Read all instructions completely before beginning installation.2. Turn off electricity before beginning installation.3. All wiring is to be performed by a qualified electrician.Manual ModeManual ModeManual ModeYou may select a light intensity at which the fixtures operate. You may select a light intensity at which the fixtures operate. You may select a light intensity at which the fixtures operate. In this case, no external dimming device is required.In this case, no external dimming device is required.In this case, no external dimming device is required.15PRODUCT GUIDELC-1CH-MULTILC-DMRJ/AWall DimmerLC-1CH-DPJDimmer PackLC-1CH-MULTILC-1CH-MULTI Dimming System/8VDCLC-1CH-MULTI Dimming System/24 VDCLC-1CH-MULTI Dimming System/24 VDCTokistar's LC-1CH-MULTI Dimmer Pack is compatible with industry-standard Tokistar’s LC-1CH-MULTI Dimmer Pack is compatible with industry-standard dimmers working on DMX ordimmers working on DMX or 0-10/1-10VDC protocol. In the manual mode, a pre-0/1-10 VDC protocol. In the manual mode, a preset light level can be set without the use of an external dimmer.Tokistar’s LC-1CH-MULTI Dimmer Pack is compatible with industry-standard dimmers working on DMX orset light level can be set without the use of an external dimmer.0/1-10 VDC protocol. In the manual mode, a preset light level can be set without the use of an external dimmer.LC Dimming System/8VDCLC Dimming System/24 VDCThis proprietary dimming system provides full-range dimming of LEDs from our LED drivers. The system components connect with LC Dimming System/24 VDCThis proprietary dimming system provides full-range dimming of LEDs from our LED Drivers. The system components CAT5e cable. Up to 25 dimmer packs may be connected in series if the total length of all CAT5e cable does not exceed 50 meters connect with CAT5 cable. Up to 25 dimmer packs may be connected in series if the total length of all CAT5 cable does from the wall dimmer to the last dimmer pack. CAT5e cables are required to units.This proprietary dimming system provides full-range dimming of LEDs from our LED Drivers. The system components not exceed 165 feet from the wall dimmer to the last dimmer pack. CAT5 cables are included with units.connect with CAT5 cable. Up to 25 dimmer packs may be connected in series if the total length of all CAT5 cable does Signal to next Dimmer Packnot exceed 165 feet from the wall dimmer to the last dimmer pack. CAT5 cables are included with units.8VDC LED Drivers TOKISTAR LIGHTING | 1116Power SuppliesDimming TOKISTAR LIGHTING | 11
元のページ ../index.html#9