LWHPart #: LC-1CH-MULTITechnical Specifications:Max. Load: 96 watts @ 24 VDCEnvironmental Rating: Dry Location/IP20Dimensions: 3/4" x 1-3/4" x 3-1/2"Part #: LC-1CH-MULTILC-1CH-MULTIWeight: 50g / 0.11 lbsTechnical Specifications :Technical Specifications:Listing: ETL Listed/CE CertifiedMax. Load : 96W @ 24VDCMax. Load: 96 watts @ 24 VDCOperating Temperature: 0~+50ºCEnvironmental Rating : Dry Location/IP20Environmental Rating: Dry Location/IP20Dimensions : W40 x L90 x H20mmDimensions: 3/4" x 1-3/4" x 3-1/2"Weight : 50gDMX ModeWeight: 50g / 0.11 lbsListing : ETL Listed/CE CertifiedIn this mode, dimmer packs are addressable and may be used Operating Temperature : 0~+50°Cwith any controller working on DMX protocol. Up to 36 Listing: ETL Listed/CE Certifieddimmer packs may be connected in series. For applications Operating Temperature: 0~+50ºCDMX Modeexceeding 36 dimmer packs, a splitter is required. Consult factory on details of DMX Splitters.In this mode, dimmer packs are addressable and may be DMX Modeused with any controller working on DMX protocol. In this mode, dimmer packs are addressable and may be used with any controller working on DMX protocol. Up to 36 Up to 36 dimmer packs may be connected in series. Analog Mode 0/1-10 VDCdimmer packs may be connected in series. For applications For operation from devices using 0/1-10 VDC protocol, For applications exceeding 36 dimmer packs, a splitter is exceeding 36 dimmer packs, a splitter is required. Consult up to 10 dimmer packs may be connected in series. For required. Consult factory on details of DMX Splitters.applications exceeding 10 dimmer packs, an additional feed factory on details of DMX Splitters.from the analog dimming device is required. Analog Mode 0-10/1-10VDCAnalog Mode 0/1-10 VDCFor operation from devices using 0-10/1-10VDC protocol, For operation from devices using 0/1-10 VDC protocol, up to 10 dimmer packs may be connected in series. up to 10 dimmer packs may be connected in series. For For applications exceeding 10 dimmer packs, an addi-applications exceeding 10 dimmer packs, an additional feed LC Dimming System/24 VDCtional feed from the analog dimming device is required.from the analog dimming device is required. This proprietary dimming system provides full-range dimming of LEDs from our LED Drivers. The system components connect with CAT5 cable. Up to 25 dimmer packs may be connected in series if the total length of all CAT5 cable does not exceed 165 feet from the wall dimmer to the last dimmer pack. CAT5 cables are included with units.Part #: LC-DMR The remote wall dimmer has a rotary dial and on/off switch. Power to the wall dimmer is provided from the LED Driver powering the first dimmer pack. The unit installs in a single-gang box.Manual ModeYou may select a light intensity at which the fixtures operate. In this case, no external dimming device is required.0/1-10 VDC In0-10/1-10VDC In0/1-10 VDC InDMX InDMX InDMX InLC-DMRLC-DMRPWM SignalPWM Signal24 VDC24 VDC24 VDC TOKISTAR LIGHTING | 1124 VDCLED Driver0/1-10 VDC to next Dimmer Pack0/1-10 VDC to next Dimmer PackDimmer PackLED DriverDMX to next Dimmer Pack24VDCDMX to next Dimmer PackDMX to next Dimmer PackSignal to next Dimmer PackPWM SignalDimmer PackSignal to next Dimmer PackSignal to next Dimmer PackPWM SignalLED DriverFixtureFixtureFixtureLED DriverLED DriverFixtureFixtureLED DriverPRODUCT GUIDELED Driver24VDC(+)24VDC(-- )SignalFixtureWall Dimmer0-10/1-10VDC to next Dimmer PackDimmer 24 VDCPackDimmer PackDimmer PackDimmer Pack24VDC(+), Signal24VDC(-)FixtureLDR24-16SpecificationsMax. Output Current : 0.67AMax. Output Power : 16WProtection: Overload, Over Voltage,Short Circuit, Over TemperatureWorking Temperature : -30°C~+50°CMechanical SpecificationsDimensions : W40 x L150 x H33mmWeight : 210gEnclosure Rating : Suitable for use in Dryand Damp Locations/IP30 RatedMounting : Flange MountLED Module Capacity2.6Watt LED Modules : 6 each1.6Watt LED Modules : 10 each1.5Watt LED Modules : 10 eachLDR24-25SpecificationsMax. Output Current : 1.05AMax. Output Power : 25WProtection : Overload, Over Voltage,Short Circuit, Over TemperatureWorking Temperature : -30°C~+50°CMechanical SpecificationsDimensions : W40 x L150 x H33mmWeight : 360gEnclosure Rating: Suitable for use in Dry,Damp and Wet Locations/IP67 RatedMounting : Flange MountLED Module Capacity2.6Watt LED Modules : 9 each1.6Watt LED Modules : 15 each1.5Watt LED Modules : 16 eachLDR24-40SpecificationsMax. Output Current : 1.67AMax. Output Power : 40WProtection : Overload, Over Voltage,Short Circuit, Over TemperatureWorking Temperature : -30°C~+50°CMechanical SpecificationsDimensions : W43 x L163 x H33mmWeight : 440gEnclosure Rating : Suitable for use in Dry,Damp and Wet Locations/IP67 RatedMounting : Flange MountLED Module Capacity2.6Watt LED Modules : 15 each1.6Watt LED Modules : 25 each1.5Watt LED Modules : 26 eachDo not turn fixtures on until the dimming wire is connected. Connect the signal wire to the negative wire when not dimming the fixture.Common SpecificationsInput Range : 100~240VACFrequency Range : 50/60 HzOutput : 24VDC (+/- 4%)LDR24-16 Safety StandardsUL8750, CSA C22.2 No. 250.0-08,EN61347-1, EN61347-2-13 independent,EN62384, J61347-1, J61347-2-13 approved,Design refer to UL60950-1, TUV EN60950-1LDR24-25 Safety StandardsUL8750, CSA C22.2 No. 250.0-08, EN61347-1,EN61347-2-13 independent, EN62384, J61347-1,J61347-2-13 approved, IP67 approved; Design refer to UL60950-1, TUV EN60950-1LDR24-40 Safety StandardsUL8750, CSA C22.2 No. 250.0-08, ENECEN61347-1, EN61347-2-13 independent,EN62384, IP67,J61347-1, J61347-2-13 approved;Design refer to UL60950-1, TUV EN60950-1Part #: LC-DMR The remote wall dimmer has a rotary Part #: LC-1CH-DP LC-1CH-DPJdial and on/off switch. Power to the wall Each dimmer pack receives a 24 VDC input Each dimmer pack receives a 24VDC inputdimmer is provided from the LED Driver from an LED Driver and sends a PWM output from an LED driver and sends a PWM outputpowering the first dimmer pack. The unit to the fixture. Logic input and output to the fixture. Logic input and output is installs in a single-gang box.is communicated through CAT5 cable. communicated through CAT5e cable.Max. Load: 96 watts @ 24 VDCMax. Load : 96W @ 24VDCDimensions: 1-1/2" x 3-1/2" x 4-1/16"Dimensions : W89 x L103 x H36mmPart #: LC-1CH-DP Each dimmer pack receives a 24 VDC input from an LED Driver and sends a PWM output to the fixture. Logic input and output is communicated through CAT5 cable. Max. Load: 96 watts @ 24 VDCDimensions: 1-1/2" x 3-1/2" x 4-1/16"Manual ModeManual ModeYou may select a light intensity at which the fixtures operate. You may select a light intensity at which the fixtures operate. In this case, no external dimming device is required.In this case, no external dimming device is required.15PRODUCT GUIDELC-1CH-MULTI Dimming System/24 VDCTokistar’s LC-1CH-MULTI Dimmer Pack is compatible with industry-standard dimmers working on DMX or0/1-10 VDC protocol. In the manual mode, a preset light level can be set without the use of an external dimmer.LC-1CH-MULTI Dimming System/24VDCLC-1CH-MULTI Dimming System/24 VDCTokistar’s LC-1CH-MULTI Dimmer Pack is compatible with industry-standard Tokistar’s LC-1CH-MULTI Dimmer Pack is compatible with industry-standard dimmers working on DMX ordimmers working on DMX or 0-10/1-10VDC protocol. In the manual mode, a pre-0/1-10 VDC protocol. In the manual mode, a preset light level can be set without the use of an external dimmer.set light level can be set without the use of an external dimmer.LC Dimming System/24 VDCLC Dimming System/24VDCThis proprietary dimming system provides full-range dimming of LEDs from our LED Drivers. The system components This proprietary dimming system provides full-range dimming of LEDs from our LED drivers. The system components connect with connect with CAT5 cable. Up to 25 dimmer packs may be connected in series if the total length of all CAT5 cable does CAT5e cable. Up to 25 dimmer packs may be connected in series if the total length of all CAT5e cable does not exceed 50 meters not exceed 165 feet from the wall dimmer to the last dimmer pack. CAT5 cables are included with units.from the wall dimmer to the last dimmer pack. CAT5e cables are required to units.24VDC Drivers TOKISTAR LIGHTING | 1116Power SuppliesNon-dimmingDimming
元のページ ../index.html#9