LWHRed(+)Black(-- )LED DriverFixtureDo not turn fixtures on until the dimming wire is connected. Connect the signal wire to the negative wire when not dimming the fixture.Red : 24VDC(+)Black : 24VDC(-)1. Read all instructions completely before beginning installation.2. Turn off electricity before beginning installation.3. All wiring is to be performed by a qualified electrician.LC-1CH-MULTI Dimming System/24VDCLC-1CH-MULTI Dimming System/24 VDCTokistar’s LC-1CH-MULTI Dimmer Pack is compatible with industry-standard Tokistar’s LC-1CH-MULTI Dimmer Pack is compatible with industry-standard dimmers working on DMX ordimmers working on DMX or 0-10/1-10VDC protocol. In the manual mode, a pre-0/1-10 VDC protocol. In the manual mode, a preset light level can be set without the use of an external dimmer.set light level can be set without the use of an external dimmer.Frequency Range : 50/60 HzOutput : 24VDC (+/- 4%)Common SpecificationsInput Range : 100~240VACSpecificationsMax. Output Current : 1.67AMax. Output Power : 40WProtection : Overload, Over Voltage,Short Circuit, Over TemperatureWorking Temperature : -30°C~+50°CMechanical SpecificationsDimensions : W43 x L163 x H33mmWeight : 440gEnclosure Rating : Suitable for use in Dry,Damp and Wet Locations/IP67 RatedMounting : Flange MountLED Module Capacity1.5Watt LED Modules : 26 eachSpecificationsMax. Output Current : 0.67AMax. Output Power : 16WProtection: Overload, Over Voltage,Short Circuit, Over TemperatureWorking Temperature : -30°C~+50°CMechanical SpecificationsDimensions : W40 x L150 x H33mmWeight : 210gEnclosure Rating : Suitable for use in Dryand Damp Locations/IP30 RatedMounting : Flange MountLED Module Capacity1.5Watt LED Modules : 10 eachSpecificationsMax. Output Current : 1.05AMax. Output Power : 25WProtection : Overload, Over Voltage,Short Circuit, Over TemperatureWorking Temperature : -30°C~+50°CMechanical SpecificationsDimensions : W40 x L150 x H33mmWeight : 360gEnclosure Rating: Suitable for use in Dry,Damp and Wet Locations/IP67 RatedMounting : Flange MountLED Module Capacity1.5Watt LED Modules : 16 each41PRECAUTIONS24VDC DriversLDR24-25LDR24-16LDR24-40Power SuppliesNon-dimming Wiring DiagramDimming Wiring DiagramsPWM Signal24VDC24 VDCDMX to next Dimmer PackManual ModeManual ModeYou may select a light intensity at which the fixtures operate. You may select a light intensity at which the fixtures operate. In this case, no external dimming device is required.DMX ModeIn this mode, dimmer packs are addressable and may be DMX Modeused with any controller working on DMX protocol. In this mode, dimmer packs are addressable and may be used with any controller working on DMX protocol. Up to 36 Up to 36 dimmer packs may be connected in series. dimmer packs may be connected in series. For applications For applications exceeding 36 dimmer packs, a splitter is exceeding 36 dimmer packs, a splitter is required. Consult required. Consult factory on details of DMX Splitters.factory on details of DMX Splitters.Analog Mode 0-10/1-10VDCAnalog Mode 0/1-10 VDCFor operation from devices using 0-10/1-10VDC protocol, For operation from devices using 0/1-10 VDC protocol, up to 10 dimmer packs may be connected in series. up to 10 dimmer packs may be connected in series. For For applications exceeding 10 dimmer packs, an addi-applications exceeding 10 dimmer packs, an additional feed tional feed from the analog dimming device is required.from the analog dimming device is required. FixtureLED DriverFixture0/1-10 VDC InDMX InIn this case, no external dimming device is required.LC-DMR42Part #: LC-1CH-MULTILC-1CH-MULTITechnical Specifications :Technical Specifications:Max. Load : 96W @ 24VDCMax. Load: 96 watts @ 24 VDCEnvironmental Rating : Dry Location/IP20Environmental Rating: Dry Location/IP20Dimensions : W40 x L90 x H20mmDimensions: 3/4" x 1-3/4" x 3-1/2"Weight : 50gWeight: 50g / 0.11 lbsListing : ETL Listed/CE CertifiedOperating Temperature : 0~+50°CListing: ETL Listed/CE CertifiedOperating Temperature: 0~+50ºCPart #: LC-DMR The remote wall dimmer has a rotary dial and on/off switch. Power to the wall dimmer is provided from the LED Driver powering the first dimmer pack. The unit installs in a single-gang box.FixtureLED Driver0-10/1-10VDC InDMX In4. Installation must comply with the National Electrical Code or related applicable regulations.5. Turn main supply to LED Driver on only after all connections have been made and tested. 6. Use only LED Drivers provided by Tokistar with the system.0-10/1-10VDC to next Dimmer Pack0/1-10 VDC to next Dimmer PackDimmer PackDimmer PackDMX to next Dimmer PackSignal to next Dimmer PackPWM SignalDimmer Pack24VDC Item (Micro Foot Light) Power Supplies & DimmingIP67IP30IP67LC Dimming System/24 VDCThis proprietary dimming system provides full-range dimming of LEDs from our LED Drivers. The system components connect with CAT5 cable. Up to 25 dimmer packs may be connected in series if the total length of all CAT5 cable does not exceed 165 feet from the wall dimmer to the last dimmer pack. CAT5 cables are included with units.
元のページ ../index.html#22