PRECAUTIONS Φ1939RequiredRequiredEnd Cap220609684.538.547.2300785010020Φ19.8*One of each item is required for a LED driver.Φ1930062Φ24Φ24KSW-CON-T/ECKSW-CON-DC-30mData Cable 30mKSW-CON-LC-10mLead Cable 10m496847.230000301000064.430T Connector with End CapKSW-EXT-DC-15mKSW-EXT-1m* This is an extension cable to connect between T connector and the fixture, or between fixtures. Up to 2 can be used per system.Data Extension Cable 15m* This is an extension cable exclusively for KSW-CON-DC-30m. It can be extended up to 60m in combination with KSW-CON-DC-30m.KSW Extension Cable 1m* NOT includes: DMX Controller, DMX Splitter, LAN Cables (cat.5e), Software, On site setting, etc.The wiring diagram is just an example.Wiring diagram varies depending on electrical specifications, content of performance, site conditions, etc.Item configuration example for the above wiring• Lighting fixture (2.4m) 1 system x 4 systems• From T connector to data converter: Max.60mKromastar Wash L900Kromastar Wash L300LED DriverData ConverterT Connector with End CapData Cable 30mData Extension Cable 15mLead CableKSW Extension CableLC-KSW-DCKSW01-L900-RGBW-20DKSW01-L300-RGBW-20DLDR24-96WLC-KSW-DCKSW-CON-T/ECKSW-CON-DC-30mKSW-EXT-DC-15mKSW-CON-LC-10mKSW-EXT-1mIndoor PRECAUTIONSOutdoor KSW-EXT-DC-15m(Max. 60m)8pcs4pcs4pcs4pcs4pcs4pcs8pcs4pcs-LED DriverLDR24-96WData Extension Cable 15mData Cable 30mKSW-CON-DC-30mIn the case of full-address, it is possible to connect up to 100 LEDs and DMX480 channels per system by combining lighting fixtures and data converters.Lead Cable 10mKSW-CON-LC-10mT ConnectorKSW-CON-T/EC• Maximum cable length from DMX controller to Data Converter end is 50m.• Maximum cable length from Data Converter to T connector is 60m.• Controllers and Data Converters are not waterproof. Please install them indoors.• Please select cables with a capacity that matches the construction con-ditions. Depending on the site environment, select cables that are water/weather resistant and comply with the local standards.Fixtures up to 2.4m can be connectedAs necessary, it can be extended with KSW Extension Cable 1m (KSW-EXT-1m).*Up to 2 cables per system.(mm)(mm)Kromastar Wash operates from Tokistar's 24VDC LED driver. This Class 2 power supply has a single output limited to 96 watts/4 amps. The input is universal ranging from 100 to 277VAC 50/60 Hz.T Connector・CableT Connector with End CapLDR24-96WTokistar's LDR24-96W has a single 96 watt output.LC-KSW-DCLDR24-96W SpecificationsInput Range : 100~277VACFrequency Range : 50/60HzOutput: 24VDC (+/- 3%)Max. Output Current : 4.0AMax. Output Power : 96WProtection : Overload, Over voltage,Short Circuit, Over TemperatureWorking Temperature: -30°C~+60°CMechanical SpecificationsDimensions : 68 x 220 x 39mmWeight : 1120gEnclosure Rating : Suitable for use in Dry,Damp and Wet Locations/IP67 RatedMounting : Flange MountSafety Standards ETL Listed to UL 2108 when used withTokistar Lighting ProductsUL8750, CSA C22.2 No. 250.0-08, EN61347-1, EN61347-2-13 IP67, J61347-1, J61347-2-13 approved; design refer to UL60950-1,TUV EN60950-1LED Module CapacityKSW fixtures up to 2.4m can be connected for one LDR24-96W.Rated input voltage : 24VDCInput signal : DMXWeight : 180g* For indoor use only 1. Read all instructions completely before beginning installation.2. Turn off electricity before beginning installation.3. All wiring is to be performed by a qualified electrician.4. Installation must comply with the National Electrical Code, or all applicable codes.5. Turn main supply to LED Driver on only after all connections have been made and tested. 6. Use only LED Drivers provided by Tokistar with the system.Data Cable 30mLead Cable 10m13DMX ControllerLAN（cat.5e）Data Converter14End Cap24VDC LED DriverData Converter for Kromastar WashKromastar Wash CablesPower Supply & Date ConverterOptionsWiring Diagram
元のページ ../index.html#8