DMX ModeIn this mode, dimmer packs are addressable and may be DMX Modeused with any controller working on DMX protocol. In this mode, dimmer packs are addressable and may be used with any controller working on DMX protocol. Up to 36 Up to 36 dimmer packs may be connected in series. dimmer packs may be connected in series. For applications DMX or AnalogFor applications exceeding 36 dimmer packs, a splitter is Inexceeding 36 dimmer packs, a splitter is required. Consult required. Consult factory on details of DMX Splitters.factory on details of DMX Splitters.Analog Mode 0-10/1-10VDCAnalog Mode 0/1-10 VDCFor operation from devices using 0-10/1-10VDC protocol, For operation from devices using 0/1-10 VDC protocol, up to 10 dimmer packs may be connected in series. up to 10 dimmer packs may be connected in series. For For applications exceeding 10 dimmer packs, an addi-applications exceeding 10 dimmer packs, an additional feed tional feed from the analog dimming device is required.from the analog dimming device is required. Part #: LC-1CH-MULTILC-1CH-MULTITechnical Specifications :Technical Specifications:Max. Load : 40W @ 8VDCMax. Load: 96 watts @ 24 VDCEnvironmental Rating : Dry Location/IP20Environmental Rating: Dry Location/IP20Dimensions : W40 x L90 x H20mmDimensions: 3/4" x 1-3/4" x 3-1/2"Weight : 50gWeight: 50g / 0.11 lbsListing : ETL Listed/CE CertifiedOperating Temperature : 0~+50°CListing: ETL Listed/CE CertifiedOperating Temperature: 0~+50ºCPart #: LC-DMR The remote wall dimmer has a rotary dial and on/off switch. Power to the wall dimmer is provided from the LED Driver powering the first dimmer pack. The unit installs in a single-gang box.Part #: LC-1CH-DP Each dimmer pack receives a 24 VDC input from an LED Driver and sends a PWM output to the fixture. Logic input and output is communicated through CAT5 cable. Max. Load: 96 watts @ 24 VDCDimensions: 1-1/2" x 3-1/2" x 4-1/16"0/1-10 VDC In8VDCDMX InLC-DMRPWM Signal24 VDC24 VDC0/1-10 VDC to next Dimmer PackFixtureDMX to next Dimmer PackSignal to next Dimmer PackPWM SignalDimmer PackDimmer Pack4228575LED driver (non-dimming)LED driver + LC-1CH-MULTI or LC dimming1. Read all instructions completely before beginning installation.2. Turn off electricity before beginning installation.3. All wiring is to be performed by a qualified electrician.AWG14 17mDimmerDimmer PackLED DriverDMX or Analog OutDimmer PackLED DriverDMX or Analog OutFixtureFixture8VDCLED DriverFixtureLED DriverPRODUCT GUIDE(mm)LDR8-40Tokistar’s LDR8-40 is a 40 Watt LED driver used to convert an AC input into an 8VDC output. It may be operated from a wide range of input voltages.SpecificationsInput Range : 90-305VACFrequency Range : 50/60 HzOuput : 8VDC (Adjustable +5% / -30%)Max. Output Current : 5.0AMax. Output Power : 40WProtection : Overload, Overcurrent, Short Circuit Operating Temperature : -30°C to + 60°C Mechanical SpecificationsDimensions : 75 x 285 x 42mmWeight : 0.97kgEnclosure Rating : Nema 3/IP65Mounting : Flange MountConnection : Knockouts for 1/2" ConduitLED Capacity0.20 Watt LEDs : 200 each4. Installation must comply with the National Electrical Code, or all applicable codes.5. Turn main supply to LED Driver on only after all connections have been made and tested. 6. Use only LED Drivers provided by Tokistar with the system.Manual ModeManual ModeYou may select a light intensity at which the fixtures operate. You may select a light intensity at which the fixtures operate. In this case, no external dimming device is required.In this case, no external dimming device is required.27PRODUCT GUIDEPRECAUTIONSLC-1CH-MULTIThe distance from the power supply to the fixture, and the load of the fixture, will determine the proper size of secondary wire. Fixtures require an individual lead. If additional wire needs to be attached, refer to the recommendation in this chart.LC-1CH-MULTILC-1CH-MULTI Dimming System/8VDCLC-1CH-MULTI Dimming System/24 VDCTokistar's LC-1CH-MULTI Dimmer Pack is compatible with industry-standard Tokistar’s LC-1CH-MULTI Dimmer Pack is compatible with industry-standard dimmers working on DMX ordimmers working on DMX or 0-10/1-10VDC protocol. In the manual mode, a pre-0/1-10 VDC protocol. In the manual mode, a preset light level can be set without the use of an external dimmer.set light level can be set without the use of an external dimmer.Recommended Lead Wire Size and Length LimitationLC Dimming System/24 VDCThis proprietary dimming system provides full-range dimming of LEDs from our LED Drivers. The system components connect with CAT5 cable. Up to 25 dimmer packs may be connected in series if the total length of all CAT5 cable does not exceed 165 feet from the wall dimmer to the last dimmer pack. CAT5 cables are included with units.8VDC LED Drivers TOKISTAR LIGHTING | 1128Power SuppliesDimming
元のページ ../index.html#15