PRECAUTIONS Wire SizeAWG14AWG121. Read all instructions completely before beginning installation.2. Turn off electricity before beginning installation.3. All wiring is to be performed by a qualified electrician.Total LengthWithin 25mWithin 44mIt is possible to connect the lighting fixtures and a remotely set power supply with an appropriate lead wire. Refer to the table for lead wire sizes and length limitation. The extension distance is a guideline distance for the fixture's maxi-mum capacity. Depending on the type of power supply, lead wire, and number of LEDs, it may be possible to extend it further.Please contact us for more information.Recommended Lead Wire Size and Length LimitationThe distance from the power supply to the fixture, and the load of the fixture, will determine the proper size of secondary wire. Fixtures require an individual lead. If additional wire needs to be attached, refer to the recommendation in this chart.Electronic transformers may not be used. The primary input to the transformer may be dimmed from industry standard phase-control dimmers, also referred to as triac dimmers. While most show very favorable results, there may be compatibility issues with certain makes and models. The following guidelines should be taken into account in selecting the proper dimming device:1. Make sure the dimmer used is suitable for use with mag-2. Some dimmers have a minimum-load requirement. Since 3. Some dimmers not only require a minimum load, but may not function properly at certain levels/loads because they do not interpret an LED load as they do a standard incan-descent load. In such cases, some dimming companies offer a “synthetic load” device to resolve this issue. Check with the dimmer manufacturer in such cases.11PRODUCT GUIDEnetic low-voltage transformers, not electronic low-voltage transformers.LEDs consume so little power, this should be given serious consideration in the selection of the dimmer.TransformerLength Limitation4. Tokistar has evaluated a wide range of dimmers, but can-not promise perfect dimming results with every make and model on the market. Additionally, manufacturers of dimmers occasionally make changes to their specifications without notice. Some older generations of a certain model might actually work more fluidly than a newer generation.5. If there is any question on compatibility, consult with us on a case-by-case basis. We work closely with many dimming companies, and can provide samples of our fixtures for compatibility testing if necessary.• Do not extend the lead wire too much, as it is very dangerous.• Please contact us if you want to extend beyond the length of the table.• Select a cable with a capacity, according to the site conditions. Select a cable that conforms to water and weather resistance standards, according to the site environment.4. Installation must comply with the National Electrical Code, or related applicable regulations.5. Turn main supply to magnetic down transformer on only after all connections have been made and tested.6. Use only appropriate magnetic down transformer.FixtureEX Socket System series operate with 24VAC magnetic transformer.PRECAUTIONSPRODUCT GUIDE12Wiring DiagramPower Supplies
元のページ ../index.html#7